Below you will find free PDF files for your Kawasaki Vulcan owners manuals . Kawasaki Ninja R Kawasaki Ninja MiB. It may not necessarily provide electronic owner’s manuals and supplementary documents for all products sold by Kawasaki. Moreover, this service may not. top > Search for Owner’s Manual (Motorcycle). How to use this service. Ninja , Ninja R, Ninja , Ninja ABS, Ninja , Ninja , Ninja ABS .
|Published (Last):||13 September 2006|
|PDF File Size:||17.82 Mb|
|ePub File Size:||8.62 Mb|
|Price:||Free* [*Free Regsitration Required]|
Stick Coil 2 Lead Connector Rear Master Cylinder Install the hose odners that its white mark side faces the air switching valve.
If cable movement is not free after lubricating, if the cable is frayed [B], or if the cable housing is kinked [C], replace the cable. Service Code 51 Stick Coil 2: Do not touch the sensing part [B] and filter holes [C] of the sensor to prevent oil contact. Torque – Brake Pedal Bolt [E]: Kawasako [B] Pedal Position Standard: So, the heater itself can not be removed.
Toothed Washer, 30 mm 1. Front Brake Caliper 6. Don’t have an account? Throttle Body Assy 4. Front Up to kg lb load: Sealant – Liquid Gasket, TB Check the oil level before each use and change the oil and filter according to the periodic maintenance chart. Other loss or damage associated with this service, for which gross negligence or malice is not attached to Kawasaki This service may be discontinued or its contents and conditions changed without notice.
If there is no continuity, go to step 3. Wheelbase 1 mm Throttle Body Vacuum Service at number of years shown or indicated odometer reading intervals, whichever comes first. When the motorcycle is down, the vehicle-down sensor operates and the ECU shuts off the fuel pump relay, fuel injectors and ignition system.
Kawasaki Ninja R – Owner’s Manual – Pages – PDF
Battery 12 V 8 Ah 3. Thrust Washer, 30 mm 1. License Plate Light Lead Connector 7.
Right Switch Housing Kawasami 2. Also, replace the steel plates if their teeth are damaged. Intake air pressure sensor trouble Inspect nija chapter 3. Throttle Full Open UR: Be prepared for fuel spillage; any spilled fuel must be completely wiped up immediately. Gaskets, O-rings, oil seals, grease seals, circlips, cotter pins or self-locking nuts must be replaced with new ones whenever disassembled.
Nonetheless, the owner’s manuals provided at this website do not necessarily reflect the corrections or updates that are included with each change in the kaeasaki manuals supplied with the products. NOTICE Do not disconnect the battery cables or any other electrical connections when the ignition switch is on, or while the engine is running.
Safety precautions for using your product are included in the owner’s manual or other documents that are supplied with your product.
Kawasaki Ninja 300 Service Manual
Never drop the throttle body assy especially on a hard surface. Oxygen Sensor Equipped Models Fan Fuse 10 A Reserve Tank Overflow Hose 2. Throttle Cable Kawxsaki 3. Water-proof Joint 2 4.
If the onwers leakage is found on it, replace the shock absorber with a new one. Page 5 All rights reserved. Stick coil shorted or not in good contact Inspect or Reinstall see chapter When they are properly matched, there is no clearance [A] be- tween the crankcase and the bearing outer races.
Clutch Pressure Plate B. Water-proof Joint 1 3.
About 40 mm 1. Upper Fairing Bracket 4.
Owner’s Manuals & Service Manuals | Kawasaki Vehicles
Front Master Cylinder 2. The push rod does not return to its original position once it moves out to take up camshaft chain slack.
If there is no continuity, repair or replace the main har- ness. Technical Information – Assist and Slipper Clutch Water-proof Joint 1 8. If whitish cotton-like wafts are observed, aluminum parts in the cooling system are corroded. Headlight High Connector 7. The rings should kawxsaki perfectly parallel to groove surfaces.